Reno, Nevada
Trenchless Sewer Line Replacement in Reno
A sewer line that is past repair can be replaced from the inside, or pulled out and replaced through two small pits, without a trench across the Reno property. Here is how the decision gets made and who does the work.
Repair or replace? What the camera settles in Reno
Nobody should quote a sewer line in Reno without first putting a camera through it, and the footage answers one question before any other: is the pipe still a pipe? A cracked, root-filled, joint-leaking line that still has its round section and its fall to the main can be rebuilt in place with a liner. A line that has collapsed, flattened, dropped into a belly or been pushed out of grade by a root ball cannot be lined back into shape; that one gets burst and replaced with new pipe along the same path. Either way the yard stays closed up. The difference is in what the contractor pulls through the old line.
What is under Reno homes
Desert subdivisions built in the big growth years used clay and then ABS, and the older cores of the cities still run on clay and cast iron. The pipe here fails less from roots than from movement: caliche and expansive soils shift with the rare heavy rains, and slab homes carry their drain lines in ground that bakes and then floods.
The daily temperature swing is hard on shallow laterals, and monsoon runoff finds every open joint. Add hard water that leaves scale inside cast iron, and a pipe that was marginal becomes a pipe that holds water in its low spots and backs up.
A bellied line in desert soil does not improve with lining; the belly stays. Those runs are burst and replaced at grade. Lines with scale and cracking but good slope are candidates for a structural liner after a thorough jetting.
How a no-dig replacement goes in Reno
The crew locates the line from the cleanout to the city connection and marks the depth at each defect the camera found. For bursting, two pits are opened: one at the house end, one at the property line or the main. A steel cable is fed through the old pipe, a bursting head is attached with a length of fused HDPE behind it, and a hydraulic puller draws the head through. The old pipe shatters into the surrounding ground and the new one occupies the same route at the same depth. The two ends are connected, the city inspects the tie-in, and the pits are closed the same day.
For a structural liner the run is jetted clean and measured, then a resin-soaked tube goes in from the cleanout by pull or inversion. Pressure holds it to the host wall while hot water or steam cures it, and what remains is a smooth, seamless pipe nested inside the original. A cutter working from inside reopens any branch lines. Water is off for the cure and back on the same afternoon.
Sewer Pipe Lining (CIPP)
A resin-saturated liner cured in place forms a new, jointless pipe inside the old one.
Details →
Pipe Bursting
A bursting head splits the old pipe while pulling new HDPE pipe in behind it, through two small pits.
Details →
Sewer Camera Inspection
See what is actually wrong before anyone quotes a fix.
Details →
Sewer Line Repair & Replacement
When a line cannot be lined: spot excavation or trenchless replacement, chosen from the footage.
Details →
Permits, inspections and the part in the street
Replacing a lateral in Reno normally takes a plumbing permit, and the section between the property line and the main may belong to the city or the utility, which means a right-of-way permit and a scheduled tie-in inspection. A trenchless contractor who works Reno regularly knows which agency owns that last stretch, pulls the permits as part of the job and books the inspector around the day of the pull. A quote that leaves permits out is not a complete quote.
Who replaces sewer lines in Reno
No installer has been verified for the Reno territory yet. Vetted lining and bursting contractors are listed by state at curedinplacepipe.net, and the form on this page or (855) 804-1434 goes to the network, which pairs the request with a qualified contractor working Reno. Whoever does the job, get the footage before the price and the method on paper.
Common questions from Reno owners
Does my Reno sewer line need to be replaced, or can it be repaired?+
A camera inspection decides it. If the pipe is round, holds its slope and the damage is cracks, roots or open joints, a liner rebuilds it in place. If the line has collapsed, bellied, flattened or lost grade, it needs replacement — pipe bursting pulls a brand-new HDPE line through the old one from two small pits.
How long will the new pipe last?+
A cured-in-place liner is rated for 50 years and more; fused HDPE installed by bursting is rated for 100. Both outlast the clay, cast iron and Orangeburg they replace by a wide margin, and neither has joints for roots to find.
How many days does a sewer line replacement take in Reno?+
Most residential sewer line replacements take one day on site. A liner cures in 2 to 4 hours with hot water or 1 to 2 with steam; bursting a typical 60-foot lateral is 30 to 90 minutes of pulling plus the two connections and the city inspection. Water is off for 4 to 8 hours and a camera run before and after is part of the job.
What happens to the lawn, driveway and landscaping?+
Lining needs a cleanout or one small access hole. Bursting opens a pit at both ends of the run, each about 3 by 4 feet and as deep as the pipe, and nothing in between is disturbed — the lawn, driveway, patio and trees stay where they are. The pits are backfilled and re-sodded the same day.
What does trenchless sewer line replacement cost in Reno?+
Trenchless replacement typically runs $60 to $250 per foot installed, which puts a 50- to 80-foot residential lateral at roughly $4,000 to $15,000. Open-cut can match that per foot but adds driveway, landscaping, sidewalk or street restoration and the permits that go with it. Every contractor listed here gives a free estimate from camera footage.
Is the estimate free?+
Yes. Estimates are free. Call now or use the form on this page; the camera inspection is normally the first visit.